Unloading, turning and moving the jh21-125 crank press by rigging to the place of installation, installation and start-up location.
In November 2019, on the territory of the Danfoss plant, Moscow region, our company performed a set of works on unloading, turning and moving the jh21-125 crank press by rigging method to the place of installation, installation and start-up.
The place where the press was installed was in the hangar, which excluded the possibility of using a crane, so the cargo was moved using rigging. Initially, it was planned to arrive the cargo in the body of an awning car in a "horizontal position", but the press came Packed in the container lying on the back wall, which caused some difficulties, since it meant that after unloading, the cargo was turned over to be installed in the working position. But the experience of our specialists allowed us to successfully perform this work without involving additional units of equipment. The press was delivered from the place of unloading to the place of installation on the Foundation, installation and start-up. The travel distance was 70m.